DS200DTBDG1ABB GE端子板 适用于单个或冗余应用

DS200DTBDG1ABB  GE端子板  适用于单个或冗余应用

产品描述

GE端子板DS200DTBDG1ABB具有2个接线端子。每个模块包含 107 个信号线端子。GE端子板DS200DTBDG1ABB还包含多个测试点、2个跳线和3个34针连接器。该板还包含 3 个 40 针连接器。该板长 11.25 英寸，高 3 英寸。它设计用于安装在驱动器内部的特定位置，并用螺钉固定到位。

首先使用螺丝刀从GE端子板DS200DTBDG1ABB上卸下螺钉。卸下信号线、带状电缆和其他电缆后，可以轻松移除DS200DTBDG1ABB。用一只手卸下螺钉并用另一只手握住它们。如果它们掉入驱动器，请先检索它们，然后再继续。它们可能会导致电缆或组件之间的高压短路。它们也可能被驱动器中强大的运动部件卡住。这可能会损坏电机或其他组件。

小心地卸下DS200DTBDG1ABB主板，防止其撞击驱动器内的其他主板或设备。您可能会不小心从其他板上敲下组件或划伤电路板表面。如果在信号线和带状电缆上标记要连接位置的连接器 ID，则电路板的安装很容易。由于多根电缆连接到电路板，请布线电缆，以免它们阻塞通风口。通风孔使冷空气进入驱动器并从组件中吸走热量。

The GE terminal board DS200DTBDG1ABB has 2 wiring terminals. Each module contains 107 signal line terminals. The GE terminal board DS200DTBDG1ABB also includes multiple test points, 2 jumpers, and 3 34-pin connectors. The board also contains three 40 pin connectors. The board is 11.25 inches long and 3 inches high. It is designed to be installed in a specific location inside the drive and secured in place with screws.

First, use a screwdriver to remove the screws from the GE terminal board DS200DTBDG1ABB. After removing the signal cable, ribbon cable, and other cables, the DS200DTBDG1ABB can be easily removed. Remove the screws with one hand and hold them with the other hand. If they fall into the drive, please retrieve them before continuing. They can cause high voltage short circuits between cables or components. They can also get stuck by powerful moving parts in the drive. This can damage the motor or other components.
Carefully remove the DS200DTBDG1ABB motherboard to prevent it from hitting other motherboards or devices within the drive. You may accidentally knock components off other boards or scratch the surface of the circuit board. Installation of a circuit board is easy if the connector ID of the location to connect is marked on the signal line and ribbon cable. Since multiple cables are connected to the circuit board, route the cables to prevent them from blocking the vents. The vents allow cold air to enter the drive and absorb heat from the assembly.