DS200GSIAG1BBB GE直流母线再生板 配置文件控制和组控制功能

DS200GSIAG1BBB 技术指标

产品描述

GE通用直流母线再生板DS200GSIAG1BBB包含3个40针连接器、2个16针连接器和6个跳线。该板还具有 1 个 8 针连接器和多个测试点。DS200GSIAG1BBB板上的所有跳线都用印在板上的一系列字母和数字来标识。所有跳线标识符都以字母 JP 开头。例如，JP1、JP2 和 JP3。板上的一个 LED 以字母 CR 开头。这些是整个行业使用的标准代码。测试点标识符以字母 TP 开头。将DS200GSIAG1BBB电路板放在平坦的表面上，电路板下方有静电保护表面。

测试点是您连接到测试仪或用探针触摸的裸露金属长矛。确保探头与测试设备兼容且正常工作。确保测试仪已正确校准，并且设备上的控件已针对正在执行的测试进行了设置。

当DS200GSIAG1BBB电路板未按预期运行且服务人员试图查明有缺陷的电路时，测试点非常有用。必须从驱动器上卸下电路板才能使用测试点。一种方法是在驱动器中安装更换板，如果问题得到解决，您就知道该板有缺陷。接下来，使用测试点测试电路板上的电路和组件，如果可能，请修理电路板。这样，如果需要更换板，您就有了现成的替换板。

The GE Universal DC Bus Regeneration Board DS200GSIAG1BBB includes three 40 pin connectors, two 16 pin connectors, and six jumpers. The board also has an 8-pin connector and multiple test points. All jumpers on the DS200GSIAG1BBB board are identified by a series of letters and numbers printed on the board. All jumper identifiers begin with the letter JP. For example, JP1, JP2, and JP3. An LED on the board starts with the letter CR. These are standard codes used throughout the industry. The test point identifier begins with the letter TP. Place the DS200GSIAG1BBB circuit board on a flat surface with an electrostatic protection surface underneath the circuit board.
The test point is a bare metal spear that you connect to a tester or touch with a probe. Ensure that the probe is compatible with the test equipment and works properly. Ensure that the tester has been properly calibrated and that the controls on the device have been set up for the test being performed.

Test points are useful when the DS200GSIAG1BBB circuit board does not operate as expected and service personnel attempt to identify defective circuits. The circuit board must be removed from the driver to use the test point. One method is to install a replacement board in the drive. If the problem is resolved, you know that the board is defective. Next, use test points to test the circuits and components on the circuit board, and if possible, repair the circuit board. This way, if you need to replace a board, you have an existing replacement board.