DS200IMCPG1 GE IAC2000I电源接口板

DS200IMCPG1 技术指标

产品描述

GE IAC2000I 电源接口板 DS200IMCPG1 可通过电缆连接到 DS200SDCC 驱动控制板。将电缆连接到驱动器控制板上的 1PL 连接器。GE IAC2000I电源接口板DS200IMCPG1装有8个保险丝，可保护板免受高压条件的损坏。在更换电路板之前，请务必首先对电路板进行故障排除并检查其保险丝是否熔断。保险丝可更换为普通且易于找到的保险丝。确保将保险丝更换为额定安培数相同且类型完全相同的保险丝。有关保险丝类型和安培数的说明，请参阅开发板随附的信息。

保险丝通过夹式连接器固定到位。您可以将保险丝从DS200IMCPG1电路板中的位置拉出，然后将更换的保险丝压入连接器。

DS200IMCPG1还装有一个 34 引脚连接器和一个 40 引脚连接器。带状电缆连接到连接器。固定夹用于通过将带状电缆锁定到位来将带状电缆固定到电路板上。首先，将固定夹从连接器上移开。然后，用手指握住连接器并将其从板上的连接器中拉出。要重新连接带状电缆，请握住带状电缆上的连接器，然后将其压入板上的连接器。然后，将夹子移到连接器上以固定电缆

The GE IAC2000I power interface board DS200IMCPG1 can be connected to the DS200SDCC drive control board through a cable. Connect the cable to the 1PL connector on the driver control board. The GE IAC2000I power interface board DS200IMCPG1 is equipped with 8 fuses to protect the board from high-voltage conditions. Before replacing a circuit board, be sure to first troubleshoot the circuit board and check whether its fuse is blown. Fuses can be replaced with ordinary and easily found fuses. Make sure to replace the fuse with a fuse of the same rating and type. For a description of the fuse type and amperage, refer to the information that came with the development board.
The fuse is held in place by a clip connector. You can pull the fuse out of its position on the DS200IMCPG1 circuit board and then press the replacement fuse into the connector.

The DS200 IMCPG1 also has a 34 pin connector and a 40 pin connector. Connect the ribbon cable to the connector. The securing clip is used to secure the ribbon cable to the circuit board by locking the ribbon cable in place. First, remove the retaining clip from the connector. Then, hold the connector with your fingers and pull it out of the connector on the board. To reconnect the ribbon cable, grasp the connector on the ribbon cable and press it into the connector on the board. Then, move the clip onto the connector to secure the cable