DS200ITXSG1ABB GE逆变器缓冲板DS200ITXSG1ABB
DS200ITXSG1ABB 技术指标
| 制造者 | 通用电气通用电气 |
| 部件号 | DS200ITXSG1ABB |
| 产品类型 | 变频缓冲卡 |
| 系列 | 马克五世 |
产品描述
GE逆变器缓冲板DS200ITXSG1ABB具有一个8针连接器、两个2针连接器和多个测试点。它还装有四个电容器。测试点是服务人员的有用工具，因为它们可以测试电路板上的各种电路。测试设备必须获得批准并正确校准。探头必须设计为与测试仪一起使用。检查探头并确保探头上的任何绝缘材料状况良好且未磨损。测试电路板时，戴上腕带并使用螺丝刀卸下将电路板连接到机架的螺钉。记下电缆的连接位置，并在电缆上标记信息，以便在重新安装主板时可以重新插入电缆。卸下DS200ITXSG1ABB主板时，请防止其刮擦机柜开口的侧面或撞击驱动器中的其他组件。将电路板放在干净坚固表面上的扁平静态袋上。例如，在工作台或办公桌上。
修复完成后，您可以重新安装驱动器，首先将主板滑入机柜。DS200ITXSG1ABB为 13 英寸 x 5.75 英寸，四个角有孔。将DS200ITXSG1ABB电路板与设计用于固定电路板的金属机架中的空间对齐，并使用四个螺钉固定它。螺钉应紧贴，但不要过度拧紧。压力过大会导致电路板破裂或碎裂.
The GE inverter buffer board DS200ITXSG1ABB has an 8-pin connector, two 2-pin connectors, and multiple test points. It also contains four capacitors. Test points are a useful tool for service personnel because they can test various circuits on a circuit board. Test equipment must be approved and properly calibrated. The probe must be designed for use with the tester. Inspect the probe and ensure that any insulation material on the probe is in good condition and not worn. When testing a circuit board, wear a wrist strap and use a screwdriver to remove the screws that connect the circuit board to the rack. Note the connection location of the cable and mark the information on the cable so that you can reinsert the cable when reinstalling the motherboard. When removing the DS200ITXSG1ABB motherboard, prevent it from scratching the side of the enclosure opening or striking other components in the drive. Place the circuit board on a flat static bag on a clean, solid surface. For example, on a workbench or desk.
After the repair is complete, you can reinstall the drive by first sliding the motherboard into the enclosure. The DS200ITXSG1ABB is 13 inches x 5.75 inches with holes in four corners. Align the DS200ITXSG1ABB circuit board with the space in the metal rack designed to secure the circuit board and secure it using four screws. The screws should be tight, but do not overtighten. Excessive pressure can cause circuit boards to crack or break
